选型指南Te.Sys接触器LC1D09到D170应用各种类型的控制系统额定工作电流le max AC-39A12A18A25A32A(Ue s 440V)20W25A20W25A2532A25/40A50A50A额定工作电压690V极数3或43或43或43或4额定工作功率220/240V2.2kW3 kW4kW5.5kW7.5 kWAC-3类380/400V5.5w7.5 kW11 kW15kW18.5kW415W440V5.5W11 kW15kW18.5kW500V5.5kw10kW15 kW5.5kW7.5w10kW15 kW18.5kW1000V辅助触点接触器内置1个常闭和1个常开瞬动辅助触点，可添加全系列的通用附加模块，最多构成4个N/C或0.10.10A0.10.13A0.1018A0.10.32A0.10.38A0.1038A(直流和低功耗接触器变阻器标准内置有浪涌抑制二极管RC电路接口继电器固态继电器接触器型号LC1D09LC1D12LC1D18LC1D25LC1D32LC1D38LC1DT20/LC1DT25/LC1DT32LC1DT40/LC1D098LC1D128LC1D188LC1D258可逆接触器型号3极LC2D09LC2D12LC2D18LC2D25LC2D32LC2D38页码接触器1/20可逆接触器(1)直流控制回路3极从LC1D09到D38,LC1D38以上的情参见进口TeSys D或TeSys F样本或与当地办事处联系(②)4极接触器从LC1D098到LC1D258,LC1D258以上请参见进口TeSys D或TeSys F样本或与当地)事处联系。140A65A80A95A115A150A170A80A125A125A200A200A200A690V1000V33311 kW15kW22 kW25 kW30 kW40kW55 kW18.5kW22kW30kW37 kW45 kW55 kW75kW90 kW22 kW25/30kW37kW45 kW45 kW59 kW80kW22 kW30W37kW55 kW55 kW75 kW90kW110kW30 kW33W37kW45 kW45 kW80 kW110kW45 kW45 kW75 kW100kWN0瞬动辅助触点，最多1个延时继电器模块17..40A17.50A17.65A17.104A17..104A60..150A60.150A132.220ALC1D40ALC1D50ALC1D65ALC1D80LC1D95LC1D115LC1D150LC1D1701/3选型指南TeSs接触器LC1D205到D620应用控制所有类型的电动机，适用于标准和重载应用控制电阻，电和电容性电路；加热，照明，功率因数补偿，变压器常规·备用电源额定工作电流le max AC-3205A245A300A(Ue s440V)le max AC-1275A315A400A1000V1000V1000V极数220240V63 kW75 kW100kWAC-3类型380400V110kW132kW160kW415V110kW132kW180kW440V110kW132kW200kW500V129kW160W660,690V129kW160kW220kW1000V100kW147kW160kW正装，与LC1D09-D170接触器上的安装相同（触点：瞬时LADNe.C,延时LADT或LADR)相应的热过战继电器手动-自动LR9F电子式TeSys T接口应用根据控制电路，带或不带接触器型号LC1D205LC1D245LC1D300可逆接触器型号用于客户组装1/41410A475A620A500A700A1000A1000V1000V1000V33110kW147kW220kW265kW335kW220kW280kW375kW250kW355kW280kW335kW450kW185kW335kW450kWLR9FTeSys T根据控制电路，带或不带LC1D410LC1D475LC1D620用于客户组装1/5特性LC1D09到D170LC1LC1LC1LC1LC1D115&D09.D18D25.D38D40A..D65AD80.D95LC1D150&DT20 DT25DT32 DT40LC1D170工作环境6901000额定冲击受电压符合1EC947标准kV6e(Uimp)符合标准1EC947-1,947-4-1,GB14048.4产品证书CCC,CE防护等级()(仅适用于前侧)电源连接符合IEC68标准TH环境温度贮存-60.+80设备周围工作5.+60允许.40.+70,用于在Uc下工作大工作海拔3000无降容9090阻性能符合1EC695-2-1标准线流件850℃接触器打开10 gn8 gn10gn8gn6gn12正弦波=11ms接触器闭合15 gn15 gn15gn10 gn15 gn抗振性能(2)接触器打开2 gn5.300Hz接触器闭合4 gn4 gn4 gn3gn4gn()下页所示接线及端子截面积可确保安全。1/6特性LC1D09到D170接触器型号LC1D09&D18D25D32D38D18&D25D40AD80&D115&D12D50A&D95D150&DT20&DT32&D65AD170D25主回路接线电缆连接(1)螺钉夹紧2根导线螺钉夹紧端1根导线连2根导线连接端子子接端子连接端子1根导线mm1.41.5.61.5.-102.5.-102.5.104.5010.120不带接线端子2根导线mm'141.561.5.62.5101.25和10.120+1.3510.501根导线1.41.61.102.5.101.354.5010..120带接线端子2根导线mm1.2.52.5.101.25和4.1610.501根导线mm*1.5.61.5.61.5.102.5.161354.50不带接线端子2根导线mm'141.561.5.62.5..102.5.161.25和4.2510.-120+1.351050蝶丝刀十字N"2N20606060606N.m1.71.72.52.51.81212≤25mm28:35mm2444母线排或接线片连接-3x165x25mm8101016.51725mm M3.5M3.5M4M43.5M6M6M8螺丝刀十字N2060606060608-101013N.m1.72.52.51.86912控制电路连接电缆连接（通过螺钉紧固）1根导线mm1.41.41412.5不带接线端子2根导线mm1.41.41.41根导线1.41.41.41.2.51.2.5带接线端子2根导线12.51-2.51.2.512.512.51…2.51根导线mm1.41.41.4不带接线端子2根导线mm141.412.5十字N"2N2N2N2N"20平口螺丝刀0606060606060606N.m1.71.7171.71.71212(1)要使用战积>4mm至10mm2的线缆连接，需要使用专用接头，以100只为销售单位（产品型号：AD96180),1/7特性LC1D09到D170LC1D09DT20D12DT25D18DT32D25DT40D098(3P)D128D188D258主触点特性A9121825A2520252532324040最高690690690690工作电流下Hz25.-40025.40025.40025.400A2520252532324040250250300450额定分断能力(440V)250250300450短时允许时受电流，1秒210210240380从冷态开始，周由温度10秒A105105145240≤40℃，且无电流1分钟A616184120时间特续15分钟10分钟A30304050设有热过电器1型A25405063防止短路(U≤690V)2型A20253540带有热过继电器对应的热过继电器使用的aM或gG熔丝额定值，请咨询当地销售办事处，每极平均抗Ith 50Hzm22.52.52.52每极耗散功率AC-30.200.360.8125(以上运行电流)AC-1W1.561.562.532交流控制电路特性额定控制电压(Uc)5060H212.69050或60Hz线因运行运行0.8.1.1Uc/50Hz和0.85.1.1Uc/60k,60℃0.3.0.6Uc,60℃平均功耗~50Hz动A20℃，Uc0.7550/60 HzVA70VA0.350/60 HzVA760Hz起动A0.7550/60 HzA70VA0.350/60 HzVA7.55060Hz动作时间(1)ms12.22ms419机械寿命50或60Hz线因15每小时的操作次数3600环境温度s60℃1/8D32D38D40AD50AD65AD80D95D115(1)D150(1)D170132384050658095115150170505060808012512520020020069069069069069069069010001000100025.-40025.40025..40025.-40025.-40025.-40025.-40025.40025.-40025.40050506080801251252002002005505508009001000110011001260166016605505508009001000110011001100140014004304307208109009901100110014001400260310320400520640800950120012001381501652082603204005505805806072841101351352502502506363801001252002002503153156363100125160160200250250对应过继电器使用的aM或gG熔丝额定值，请咨询当地销售力事处21.5151.50.80.60.60.62.43.76.35.17.27913.513.555.49.69.612.524242412.-69024.38024.66024.50024.500030.6Uc,55℃03-0.5Uc,55℃0.81.1Uc50Hz和0.8.1.1Uc50Hz和08.-1.15Uc,5060Hz,55℃0.85-1.1Uc60Hz,60℃0.85.1.1Uc60Hz,60℃0.30.6Uc,60℃03.0.6Uc,55℃03-0.5Uc,55℃2003003000.750.750.750870160245280.350280..35020220.30.303030.9715262-182203000.750.750.75080.97014024528035022220.30.303030.97.513262.182.184.56.103.83.4.512.2212.2612.2620.3520.3520.50203520.354.194.194194.196.206.-20407540.75888156644883600360036003600360036002400120012001/9特性LC1D09到D170直流控制电路特性LC1D09.-D38DT20.-DT4012.440额定绝缘电压符合IEC947-1标准690运行0.7.-1.25Uc60℃宽范由0.1.0.25Uc60℃20℃，及Uc下起动平均功耗吸持5.4闭合"C"ms55打开ms20ms28百万次运行次数30最大操作顿率每小时操作次数3600环境温度g60℃低功耗控制电路特性②额定绝缘电压符合EC947-1标准690最大允许电压直流控制电路，一2502.4(0.71.25Uc吸持2.4ms70打开ms250.7至125Uc0.10.3Ucms40机械寿命百万次运行次数30环境温度≤60℃操作次3600(☒)低功耗产品请参概进口TeSys D样本，或与当地办事处联系，1/10